Mohawk A-7, Manual

Page: 23 / 74

MOHAWK MODEL A-7
15
Cable Care & Maintenance
This lift incorporates a high strength synthetic cable which is used to prevent lift collapse in
the unlikely event of a chain break. A few guidelines about its general use will help you to
increase the life of the cable and assist you in achieving the best performance from our
product.
Abrasion and Sharp Edges:
Abrasion and sharp edges are a cable’s worst enemies. Check
all equipment prior to use to make sure there are no burrs or sharp edges.
Cleaning:
Dirt on a cable can penetrate the cover strands resulting in abrasion in the core as
well as on the cover. Water facilitates the introduction of dirt particles into the cable.
When cable subjected to wet conditions, particularly where dirt is an issue, wash cable
with fresh water and allow to air dry out of direct sunlight. For a thorough cleaning, soak
your cables in warm water with a mild detergent (not bleach). When possible, use a front
loading washer; otherwise, wash your cable in a mesh bag or pillowcase to avoid
tangling.
Rinse thoroughly and then hang them up to dry out of direct sunlight.
Eliminating Twist:
Twist increases the likelihood of the cable kinking and jamming in
equipment. Severe twist can cause the cable to get out of round, resulting in higher wear
rates and reduced strength. Eliminating twist from a cable will make the cable easier to
handle and increase its life.
Chemicals:
Synthetic fibers have good chemical resistance. However, exposure to harsh
chemicals, such as acids and alkalis, should be avoided.
Damage:
Inspect all cables frequently for signs of wear or damage, especially at eyebolt
areas. Retire any cable that is cut, worn or abraded.
Sunlight:
With time, all synthetic fibers will undergo degradation when exposed to sunlight.
Tensile Strength:
The tensile strength is the load at which a new cable, tested under
laboratory conditions, can be expected to break. Age, use and the type of termination
used, such as knots, will lower tensile strengths significantly. A cable should always be
taken care of. This is important to ensure that you get the most out of it and enhance your
performance. Here is a list of the many things that you can do in taking care of your
cables:
�
Check your cable regularly. Just like the rest of your equipment, ocular inspection is very
important. Check your cable for signs of wear and tear such as damaged sheath, fraying,
and abrasion during each inspection
�
Make sure that your cable is clean. Wash it with water and non-detergent soap. Avoid
using bleach and other chemicals that can weaken the nylon cable. Air dry your cable
away from direct sunlight.
� Keep your cable away from direct sunlight, acids, and oxidizing agents that can weaken
your cable and shorten cable life.