REAR VIEW
11
10
4
5
6
7
12
8
3
2
1
(1) DC JACK
5.5 x 2.1mm negative center, supply with DC 9V.
(2) BUF IN (Buffered Input)
Signal input via this jack is fed to a buffer circuit prior to being sent to the loops.
(3) BUF OUT
This jack outputs buffered input signal only when the guitar connects BUF IN jack.
(4) NBUF IN (Non Buffer Input)
This jack directly sends singal to the loops.
(5) OUTPUT
Guitar signal goes through loop3, loop4, loop Green and loop Blue then outputs here.
(6) LOOP SEND
Send jack of loop3/loop4/loop Green/loop Blue, connects to input jack of guitar pedal.
(7) LOOP RETURN
Return jack of loop3/loop4/loop Green/loop Blue, connects to output jack of guitar pedal.
(8) AMP FOOTSWITCH
FS1/FS2 are two normally close, latch type footswitch for amp switching. FS2 is mono
type jack while FS1 is stereo, the tip of FS2 automatically connects to ring of FS1
when FS2 doesn
’
t insert a cable.
9
(9) LOOP5 (ISOLATE)
It
’
s an isolated loop,
The S jack also could be used at latch type footswitch (Normally close) for amp switching,
the OUT jack also could be used as latch type footswitch (Normally open).
Note: D
which could work as either a series or a parallel loop.
o not insert any cables into other jacks when S/OUT is used as footswitch.
(10) TUNER
This jack connects to INPUT jack when the unit is muted, usually it connects to a tuner.
(11) MIDI JACKS
MIDI OUT transimit MIDI messages, MIDI IN receive MIDI messages.
(12) EARTH TERMINAL
Connect the enclosure to earth via this terminal if necessary.
4
