10. TURN OIL BAG INSIDE OUT AND FIT OIL BAG "VEE" SECTION INTO GROOVE IN SEAL
HOUSING(28).USING SMALL OIL BAG CLAMPS AND SCREWS & NUTS CLAMP THE OIL BAG TO
THE SEAL HOLDER. TURN OIL BAG TO CLAMP THE LARGER SIDE "VEE" SECTION TO THE
GROOVE IN THE LOWER BEARING BRACKET IN THE SAME WAY.
11. FIT ONE DRAIN PLUG WITH "O" RING IN LOWER BEARING BRACKET AND FILL OIL IN
THE OIL BAG. PERIODICALLY PRESS THE OIL BAG TO LET AIR ESCAPE SO THAT FILLING
IS PROPER AND NO AIR IS ENTRAPPED IN THE OIL BAG.(A SMALL AMOUNT OF AIR IN THE
OIL BAG WILL NOT BE DETRIMENTAL IN ANY WAY).REPLACE PLUG WITH "O" RING.
12. SLIDE ON WEAR PLATE AGAINST LOWER BEARING BRACKET AND TIGHTEN THE SAME. FIT
KEY(25) ON THE SHAFT AND SLIDE ON IMPELLER. CLEARANCES BETWEEN IMPELLER AND
WEAR PLATE CAN BE ADJUSTED BY MEANS OF THE TRIMMING SPACERS(27).TIGHTEN NUT(23)
AND SEE THAT ROTOR SHAFT IS FREE.
13. FIT OUTER CASING ON TOP BRACKET WITH "O" RING. FIT DIFFUSER AND ADJUST
CLEARANCES. SLIDE ON DIFFUSER WASHERS(22) AND FIT DIFFUSER (19) AGAINST THE
OUTER CASING(10). TIGHTEN BY MEANS OF NUTS(18). FIX STRAINER, BASE PLATE AND
TIGHTEN NUTS(18)
OIL SPECIFICATIONS
A) H.P. ENKLO OIL 46/48
B) SHELL TELLUS 29.
C) CHEVRON UNIVOLT 60/N61
PARTS CATALOG
1. COMPONENTS LIST : AS PER DRAWING NO. DW/130/00 (SHEET 1 & 2).
DRAWINGS :
1. SECTIONAL ASSEMBLY(DW/130/00)(SHEET 1)
2. SEALING ARRANGEMENT WITH MATERIAL PARTS LIST (DW/130/00)(SHEET 2)
