Reliable liquid dispensing
at an affordable price
3
6. Connect inlet tubing to inlet port located in the face of the rotary shear valves. The
default inlet tubing has an ID of 0.066” and is indicated by yellow strain relief.
7. Connect outlet tubing to the ports located on top of the of rotary shear valves.
Connect other end to the dispense head, if not already done. The default outlet
tubing has an ID of 0.045” and is indicated by red strain relief.
8. Connect the inlet kit to the bottom of the inlet manifold.
DISPENSER OPERATION
Refer to figure 1-2 for visual assistance with the following instructions.
1. Turn on the dispenser
2. Set Syringe Size – Press the [
Select]
key until the arrow on the left side of the
display points to
Syringe
. Press the [
Stop / -]
or [
+ / Start]
key until the desired size
is displayed (standard sizes – 1.0, 2.5, or 5.0 mL).
3. Set Dispense Volume – Press the [
Select]
key until the arrow in the display points to
Volume
(default position). Press the [
Stop / -]
or [
+ / Start]
key until the desired
volume is displayed. See specification section for available range for each syringe
size.
4. Set Dispense Speed – Press the
Select
key until the arrow on the left side of the
display points to
Disp SPD
. Press the [
Stop / -]
or [
+ / Start]
key until the desired
speed is displayed (range is 1 – 10).
5. Set Fill Speed – Press the [
Select]
key until the arrow in the display points to the
Fill
SPD
. Press the [
Stop / -]
or [
+ / Start]
key until the desired speed is displayed
(range is 1 – 10).
6. Insert the inlet side of inlet tube into fluid reservoir and the dispense head of the
outlet tube into an appropriate catch container.
7. Prime syringe - Press the [
Mode]
key once to access dispenser’s Prime function.
Press [
+ / Start]
key. When you are satisfied that the syringe is sufficiently primed
(minimal bubbles in the syringe and tubing), press the [
- / Stop]
key.
8. System shutdown - Press the [
Mode]
key two times to select the
Empty function
.
Press [
+ / Start]
key to activate the return of system fluid to the reservoir. The
dispenser will cycle through the emptying process twice then stop automatically.
Repeat the process until the syringe and tubing are sufficiently empty of fluid.
