F
Manual - Vector SR65
www.modster.at
21
Always replace the drive shaft immediately in case of damage or visible wear, otherwise fur-
ther damage may occur.
It is recommended to lubricate the drive shaft, cardan shafts and other moving parts after 2-3
hours of use. Lubrication also serves as water protection and prevents water from entering the
fuselage through the fabric bushing.
Always replace any parts that show visible wear or damage.
1. Disconnect the coupling between the mo-
tor and the drive shaft.
2. Loosen the set screw on the boat shaft and
remove the boat shaft from the stern of the
boat.
3. Remove the drive shaft by sliding it out of
the fabric bushing. Clean the drive shaft of
lubricating oil and other materials. Then lu-
bricate the drive shaft completely with ma-
rine grease all the way to the drive motor.
4. Tighten the set screw.
5. Carefully replace the drive shaft, making
sure there is 1-2 mm clearance between the
drive motor and the screw strut to allow
enough clearance for heavier weight.
Caution:
Running the boat in salt water is not allowed
and will void the warranty. If the boat has been
driven in salt water, clean it with fresh water
after each use and lubricate the
drive parts.
WARNING: Due to the possibility of corrosion, the use of the RC boat in salt water is at the
in salt water is at the sole discretion of the user.
Maintenance
Summary of Contents for Vector SR65
Page 1: ...BETRIEBSANLEITUNG MANUAL ...
Page 27: ...27 www modster at ...
