MODSTER SR100 Hurricane, Manual

Page: 22 / 34

F
Manual - MODSTER SR100 Hurricane
22 www.modster.at
Installation und Nachtjustierung
1. Setup the display base as shown in picture.
Insert the tubes into the sockets, no gluing is
required.
2. Fix the keel, waterproof rubber piece and bal-
last with a HM5*25mm screw, using a H4.0mm
allen key.
3. Setup the keel, waterproof rubber piece into
hull by HM5*50mm screw, using a H4.0mm
allen key.
4. Insert the rudder from hull bottom to deck
through a rudder arm, connected with a clip,
make sure rudder is able to rotate freely. Then
insert push rod through the knob on rudder arm,
keep rudder in center position and tighten the
knob with a H2.0mm allen key. Stick the water-
proof cover to the deck.
5. Connect backstay crane, forestay crane , short mast, shrouds cross, long mast and the pre-installed
main sail & boom by the order of above instruction. Remember to hang the main sail on the mast with
the 6pcs luff rings.