2
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
INSTALLATION
3. Remove the mounting screw (C1) and gasket (F1) from the fixture.
4. Drill a hole in the wall aligned with the key-hole located in the mounting back plate, insert the plastic anchor (E1) to the wall.
5. Secure the mounting plate to the junction box using junction box screws (B1). Fasten the mounting plate to the wall using the wood screw
(D1). The side of the mounting back plate marked “GND” must face out.
6. Connect the fixture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE
7. Place the fixture on the mounting back plate, and secure it with mounting screw (C1) and gasket (F1).
8. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow
moisture to escape Fig.3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
FIG.1
Back Plate Dimensions
9 1/2”
2”
4”
1 1/2”
3 3/4”
Junction Box
Caulking
Fig.3 Sealing
B1
A1
E1
D1
F1
C1
Junction Box Screw
Wire Connector
Plastic Anchor
Wood Screw
Gasket
Mounting Screw
Mounting Back Plate
Fixture
Ground
Wire Screw
Ground Wire
Junction Box
INSTALLATION INSTRUCTION
706 - Outdoor Wall Sconce
WS-W70612
