FR-W2008
Mykonos 5 Instructions
12
2. Hanging the Fan
1. Disconnect power at the breaker to the fan location. A licensed
electrician must install the fan.
2. Remove 1 of 2 screws from the bottom of mounting bracket and
save for use in section 9. Loosen the other screw (Fig. 2).
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in (Fig. 2A).
4. Secure the mounting bracket to the ceiling outlet box with the
screws and washers provided with your outlet box.
5. Take out the set screw located in the hanger ball, lower the
hanger ball and remove the cross pin. Remove the hanger ball
from the hanger ball/downrod assembly (Fig. 2B).
6. Remove the clevis pin and cotter pin, and loosen the two collar
screws from the motor collar (Fig. 2B).
7. Carefully feed the motor wires and safety cable up through the
downrod. Thread the downrod into the collar.
8. Align the holes of downrod and collar and insert the cotter pin
and clevis pin. Tighten the two collar screws (Fig. 2B).
9. Slip the coupling cover, canopy screw cover (painted side face
down), and canopy (opened side up) onto the downrod (Fig. 2C).
Coupling cover goes all the way to the bottom.
REMEMBER
to turn off power at the breaker.
Follow the steps below to hang your fan properly:
WARNING:
Failure to properly install the cotter pin and/or
tighten the screws could result in the fan loosening and
possibly falling.
