21
FH-W1802
13. Wall Control Operating Instructions
(cont.)
Pairing
If you need to re-pair your fan or you want to pair a second wall
control:
1.
Power cycle your fan by turning off the power at the
circuit breaker.
2. Press and hold
and
buttons on wall control
for 10-15 seconds.
3. The LED will blink green then remain solid green.
4. The green LED along with audible beeps will indicate
that pairing is successful.
5. Test wall control for functionality.
Unpairing
NOTE:
Unpairing must be completed within 3 minutes of turning
the power on to the fan receiver.
1. When you re-engage power to the fans you want to unpairing,
press and hold the
and
buttons for 4 seconds.
2. The LED will alternate red/green, blink green, and the receiver
will beep to indicate that unpairing is successful.
Multi Location Wiring
1. Install the wall control using the wiring diagram below.
2. Individually pair each of the wall controls with the fan receiver
using the pairing instructions in the previous section.
NOTE:
Pairing must be completed within 3 minutes of turning the
power on to the fan/receiver.
FIG.25
Fan
Line/Hot
Wall
Cont
roller 2
Wall
Controller 3
Wall
Cont
roller 1
Neutral/White
If Applicable
Ground (Green
or Bare)
Fan
Line/Hot
Wall
Cont
roller 2
Wall
Controller 3
Wall
Cont
roller 1
Red
If Applicable
Wall
Cont
roller 2
Ground (Green or Bare)
Neutral/White
