FH-W1811
Aviator Flush Instructions
12
1. Disconnect power to the fan location at the breaker. A licensed
electrician must install the fan.
2. There are four screws on top of the motor assembly. Remove two
that are on the opposite of each other and save for section 10.
Loosen remaining two.
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in Figure 2.
4. Secure the hanger plate and hanger gasket to the ceiling outlet
box with the screws and washers provided (Fig. 2).
REMEMBER
to turn off power at the breaker.
Follow the steps below to hang your fan properly:
3. Attaching The Fan Blades
4. Attaching Decorative Lower Cap
1. Place blade on motor as shown in Fig. 3 and secure with the
blade attachment screws and washers.
2. Repeat this procedure with the remaining blades (Fig. 3).
3. Secure the bottom of the blades together using the provided
blade collector ring and hardware (Fig. 3A).
1. Tightly twist the decorative lower cap onto the
motor assembly (Fig. 4).
2. Installing the Mounting Bracket
Summary of Contents for Aviator Flush
