9
When the installation is ready, make sure that the power supply has fuse
with the specification of 10A, 220V, 50 Hz (WD 745 WAM) and 15A,
220V, 50 Hz (WD 1057 GAM). When the heating function is used, the
maximum current of the washing machine is 10A. Make sure the non-
overloaded power supply (current, voltage, and cable) fills the
requirement to operate this appliance on a normal load.
•
The washing machine must be grounded, so whenever there is a
problem, the current can be conducted to the ground and
minimize
the risk of short circuits. If you are not sure if the washing machine
has been properly grounded or not, you can contact the
experienced technician.
•
The pressure of supply water is between 50kPa until 800kPa for the
normal operation of the washing machine. If the water supply is too
low (below 50kPa), the input water valve may not work normally or
the washing time becomes longer, and the display will show error
code ”SF” (WD 745 WAM) or ”E4 (WD 1057 GAM).
•
Check all connections on input water supply, valve, and faucet to
avoid water leakage.
•
Position the washing machine on the floor, platform, or structure
with rigid support in a dry environment in order to avoid electric
shock and fire (Avoid direct sunlight and room temperature shall not
be below 0 ˚C
).
•
Avoid positioning the washing machine near heat source such as
coal or gas stove. Clearance should be 25mm for top, right, and left
side. For rear, 51mm is required.
•
The result of the washing machine depends on the effectiveness of
the detergent. The dirt on the clothes may not be able to vanish by
using bad quality detergent. Please clean the dirt on the clothes
like explained on this book before being washed by washing
machine.
PART 3: FIRST STEP BEFORE INSTALLATION