Modena RF 2252 L, Manual

Page: 16 / 22

English 14
Before Using Your Refrigerator
- Remove the exterior and interior packing.
- Before connecting the refrigerator to the power source, let it stand upright for approximately 4
hours. This will reduce the possibility of a malfunction in the cooling system from improper
handling during transportation.
- Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page
15)
Installing Your Refrigerator
- This appliance is designed to be free standing only, and should not be recessed or built-in.
- Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully
loaded.
- Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper
air ventilation. Adjust the feet to keep the refrigerator level.
- Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Ambient temperature below 50°F or above 85°F will hinder the performance of this
appliance.
This unit is not designed for use in a garage or any other outside installation.
- Avoid locating the refrigerator in moist areas.
- Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
This unit is not designed to be installed in an RV or used with an
inverter.
-
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for
2~3 hours under before placing food in the refrigerator or freezer compartment.
OPERATING YOUR REFRIGERATOR
Temperature Settings
- Your refrigerator has one control for regulating the
temperature. The temperature control is located on the
middle of the refrigerator compartment.
- The first time you turn the unit on, adjust the temperature
control knob
to “5” and run for at least 2 hours before
putting foods inside. This will ensure the cabinet is
thoroughly chilled before food is put in.
- The range of the REFRIGERATOR temperature control is
from position "1" the warmest to "5" the coldest. Adjust the
temperature control to the setting that best suits your
needs. The setting of “3” should be appropriate for home or office refrigerator use.
- NOTE;
-
If the unit is unplugged, loses power; you must wait 3 to 5 minutes before restarting the unit.
Part 3 : How to Use
Part 2 : Installation