English 14
2. Make the 17 cm hole for extensible pipeline if the system will
use a suction hood ducting / exhaust. Punch a hole through
all the markings on the template by using a drill with a
diameter of 8 mm. Then put the plate holder with dynabolt and
fischer. Ins ert 4 pieces of angle iron on the plate holder with 8
pieces of M5 screws and bolts, then connect the other 4
pieces of angle iron with 16 pieces of M5 screws and bolts and
set the length of the connection brackets according to t he
distance to the cooker hood suction (c onnection bet ween
brackets should not be less than 100 mm).
3. Attach the extensible pipe to the hole if the suction hood will
be used with the system ducting / exhaust.
4. Install the chimney above the plate holder with 4 screws, then
funnel down close to the top and attach a hook to hold
temporarily.
5. Replace the glass panel (for certain types) with 4 piec es of
bolts and rubber rings and adjust its position appropriately.
6. Lift the main body of the cooker hood onto the angle bar and
then fix it into position using the 16 pieces of M5 screws.
IMPORTANT: This stage of the installation process must be
completed by two people. The 16 pieces of M5 screws must
be securely tightened.
7. If you are going to be using the hood in extraction mode, you
should fix the ducting hos e to the c eiling. Remove the hanging
hook and then slide the lower chimney section downwards,
until it rests against the main body of the cooker hood.
-
The electrical connection must correspond to the electrical
requirement noted on the rating plate, which is placed
inside the cooker hood. The applianc e should no w be
connected to the electrical supply.
-
Check that the appliance is operating correctly by
selecting each speed and switching the light bulbs on and
off.
