English
8
1. Take the machine out of the carton and let it stand vertically to connect the socket.
2. Connect it to the earth wire.
3. Install the tank (14) onto the machine, insert the impeller (4), pure the tanj with beverage and
connect the power. Press the refrigerating switch (15), then the fan and the compressor will start
working. If you press the stirring switch of each tank, the impeller will rotate normally.
Attention:
The beverage cannot exceed the marked line on the tank, which is marked at the corner of the tank.
1. Cut off the power supply and remove the cover.
2. Remove the paddle first; lift the tanks through joggling them from side to side to make the tank
separate from the refrigeration barrel.
3. Clean the tank with warm water and mild detergent solution.
4. After the cleaning, take the allotypic obturating rings out of the stainless steel refrigeration barrel.
Put them at the bottom of the tank. Then water the stainless steel refrigeration barrel. And return
the tank back on the stainless steel barrel. (Attention: User have to follow this sequence,
otherwise it may cause leaking).
Warning:
Turning on the machine without beverage will affect the performance of the machine.
There should be enough beverages when heating or refrigerating. Otherwise it will have effect on
the transmission of the temperature when cooling.
When refrigerating, the space of time between turning off and restarting should not less than 5
minutes.
The machine is not suitable to be used outside. It should be used in the environment temperature
between 5°C~38°C.
COLD DRINK DISPENSER - CP 4200C
COLD DRINK DISPENSER - CP 4300C
Steering system
Steering system
Volume: 2 x 12 Liters
Volume: 3 x 12 Liters
Refrigerating rate: 350 W
Refrigerating rate: 370 W
Refrigerating temperature:8~10 °C
Refrigerating temperature:8~10 °C
Product Dimension
Product Dimension
Length: 410 mm
Length: 610 mm
Width: 470 mm
Width: 470 mm
Height: 690 mm
Height: 690 mm
Weight: 30.5 Kg
Weight: 38 Kg
The refrigeration temperatures is for the normal environment. They are different from region to region.
Specifications of this appliance may change without notice to improve the quality of the product. Figures in
this manual are schematic and may not match your product exactly.
Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in
accordance with the relevant standards. Depending on operational and environmental conditions of the
appliance, values may vary.
Part 3: Cleaning and Maintenance
Part 2:
Installation
Part 4:
Specification
