English
16
Room air ventilation
The air in the room that will be put gas appliances must have good ventilation so that air can flow / move
smoothly (there is circulation), if the air in the room can Not flow then the air in the room will contain more
combustion of the gas compared to oxygen. It will cause the flame on the stove / burner is Not perfect (a
yellow flame bec ause lack of oxygen). Therefore, the room t hat will be put gas appliances should have
good ventilation.
Open the carton wrapping stove, then take it and put the stove on flat surface.
ADJUST THE STOV E ON KITCHEN TABLE
-
Stove can be installed on the kitchen table as long as the table is resistant to heat. To make a hole
at the kitchen table use cardboard templates to customize the size. Make a hole should be
proportional Not too wide or too small. Check if the size of the hole on the kitchen table is
appropriate to put the stove.
-
If the stove with a top plate of glass will be installed parallel to the tile, to install make a distance of
at least 2 mm for expansion.
-
The size of the hole to put the stove on the kitchen table is as follows :
Type : BH 1725 MC
A = 660 mm
B = 360 mm
Attention!
-
If the stove is installed with oven underneat h, separator panel must be
placed under the stove and frame underneath with a minimum distance
of 10 cm.
Note:
For the size of the hole a few other models that are Not contained
In the above illustration can be seen in the table of specifications or
can be consulted to MODENA Service Center.
Part 3 :
Installation
