page 4 of 5
7. Use drill of 2.0 mm pitch to pre-drill all holes.
8. Re-drill the bigger holes of 7.0 mm.
9. Counter-sink the holes of 2 mm. Use a 90°-counter-sunk.
10. Use a fine fret saw or similar to saw the display frame and
clean the edges with a fine file.
10. Preparing the bottom case part
The case has to be prepared to contain the cable corresponding to
the following drawing by milling or sawing.
33,5
5
5
Einfräsung
11. Mounting into the case
After concluding the assembly of the main PCB and the display
module, they are mounted to the top case part.
1. Insert the 4 long counter-sunk screws from the case front (A,
B, C, D), add 2 washers each and tightened with 1 short
threaded stud.
2. Cut out the white areas of the front sticker and attach it to the
case. The sticker matches exactly the framed part of the case.
Work very precisely here.
3. Add one washer each, mount the main PCB and fix it with the
remaining 4 short threaded studs.
4. Mount the bottom case part and fix it using the case screws.
Pay once again attention not to quench the SX-bus cable.
5. The rotary knob is assembled. Leave a space of about 1mm to
the front to ensure the push button option of the rotary switch
6. Attach the cover to the rotary knob.
Drilling template
Please cut this drilling template carefully and use it for the case according to the assembly instruction point 9
Displayausschnitt
fräsen
D
46,0
2
1
,5
28,2
8
,7
C
A
B
Respect the following remark if you
print this document yourself:
You may only use this drilling
template if you printed this docu-
ment in original size!
To do so, select “Page adjust-
ments: None” in your printer set-
tings.
The template has to have a width of
119.2 mm.
