Model Tech Magic Formula 3D ARF, Manual

Page: 24 / 48

24
❑
With the fuselage upside down, set the engine onto the engine
mounting beams.
❑
Using a ruler, measure the distance from the firewall to the back of
the spinner backplate. Adjust the depth of the engine so that the
measurement is 4-1/2".
❑
Using a pencil, carefully mark the locations of the engine mounting holes onto the engine mounting beams.
❑
Remove the engine and drill 3/32" diameter pilot holes through the
engine mounting beams at the marks you drew.
✦ ✦
✦ ✦
✦
IMPORTANT
✦ ✦
✦ ✦
✦
Be careful that you drill the holes straight down
and not at an angle.
❑
Carefully enlarge the 3/32" diameter pilot holes, using a 5/32"
diameter drill bit.
❑
Install the engine using four M4 x 25mm socket-cap screws, eight
M4 flat washers and four M4 lock nuts.
☞
Tighten the screws and lock nuts firmly to hold the engine securely
into place.
❑
Kwik Bond Thin C/A
❑
# 1 & # 2 Phillips Head Screwdrivers
❑
Wire Cutters
❑
Needle Nose Pliers
❑
Electric Drill
❑
1/16" & 5/64" Drill Bits
❑
Ernst Airplane Stand
❑
Ruler
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
SECTION 13: THROTTLE CONTROL SYSTEM INSTALLATION
❑
(1) 13-1/4" Plain Wire w/Z-Bend
❑
(1) Adjustable Pushrod Connector w/Machine Screw & Nut
STEP 1: INSTALLING THE THROTTLE SERVO
❑
Install the rubber grommets and brass collets onto your throttle servo, making sure to install the collets with the flanges toward
the bottom of the servo.
Continued On Next Page
☛ ☛ ☛ ☛ ☛