Page
❑
Install the 90º bend in each pushrod wire into the holes that you enlarged
in the servo arm, using two snap-keepers.
☞
The pushrod wires should be orientated on top of the servo arms.
❑
Center the aileron servo, then install the servo horn onto the servo, making
sure that the servo horn is centered.
❑
Install the servo horn retaining screw to secure the servo horn to the
servo.
❑
Use a couple of pieces of masking tape, taped between the ailerons and
the wing, to hold the ailerons centered.
❑
With the servo horn and both ailerons centered, thread one clevis onto
each pushrod wire and snap the clevises into the adjustable control horns.
❑
Remove the masking tape and move the ailerons up and down several times to ensure that the linkage assembly does not bind.
It should operate smoothly in both directions.
LANDINg gEAR INSTALLATION
YOU'LL NEED THE FOLLOWINg PARTS FROM THE KIT:
YOU'LL NEED THE FOLLOWINg TOOLS AND SUPPLIES:
❑
# 2 Phillips Head Screwdriver
❑
Modeling Knife
❑
Electric Drill
❑
(2) Landing Gear Wires
❑
(2) Wheels
❑
(4) Mounting Straps
❑
(8) M3 x 12mm Wood Screws
❑
(2) Wheel Spacers
❑
(2) Wheel Collars
❑
(2) M3 x 5mm Machine Screws
❑
5/64" (2mm) Drill Bit
❑
Straight Edge Ruler
❑
Pencil
STEP 1: INSTALLINg THE LANDINg gEAR WIRES
❑
Cut away the covering material from over the two landing gear mounting
slots in the bottom of the wing. One landing gear mounting slot is located in
each half of the wing, 2-1/8" (54mm) out from the center of the wing. Each
landing gear mounting slot is 3-1/4" (86mm) long 1/8" (3mm) wide.
