![Model Shipways Western Mountain Buckboard Wagon Instruction Manual Download Page 10](http://html1.mh-extra.com/html/model-shipways/western-mountain-buckboard-wagon/western-mountain-buckboard-wagon_instruction-manual_1817296010.webp)
the holes are towards the top edge and on the back part the top edge is arced.
Remove the building square from WB-1 basswood sheet and sand the edges smooth.
3.
Carefully cut and sand the two angled sides of the seat back such that the edges mate flush
4.
with the seat sides when held square to them. Use the building square on a flat surface to
check. This is a critical step so take time and dry fit to check. (See photo 6)
Carefully cut and sand the two bottom edges of the two seat sides and the bottom edge of
5.
the seat back such that when held together will sit flush on the surface of the seat base.
(See Photo 6) Also slightly round the two (2) top corners of the seat back.
Photo 6
Once all edges are dry fitted then stain and spray with Clear Matte Finish.
6.
Apply Weldwood glue to one side of the angled edge seat back and glue to the seat side on
7.
a flat surface using the building square and let the glue set. (See Photo 7)
Summary of Contents for Western Mountain Buckboard Wagon
Page 33: ...Reference Photos...
Page 34: ......