2
Inserting and Attaching
the Motor Mount
Step 1 –
Refer to the drawing below to
locate the bottom of the stage tube by the
1 1/8” fin slot distance. Using a Q-tip or your
little finger apply glue liberally around the
inside end of the lower body tube ½” in at the
end of the slotted for the fins.
Important:
Do the following motor mount
insertion in one move. Do not stop until the
motor mount is in the correct position.
Step 2 –
Insert the motor mount and push
in until the bottom of the motor tube is flush
with the bottom on the lower body tube. Set
aside to dry.
Attaching the
Launch Lug
and Fins
Step 1 –
Apply a thin line of glue to the
launch lug and attach where marked on the
lower body tube and set aside to dry for a few
minutes.
Step 2 –
Apply a thin line of glue to the
outside of one of the fin tubes along the
length. Attach 2 fin tubes together and set
aside to dry for a few minutes on a flat
surface to keep them aligned parallel to each
other. Do this for 3 pairs of fin tubes.
Step 3 –
Apply glue in a thin line along the
length of the first fin tube pair in 2 places and
the launch lug. Refer to the fin tube layout
guide on this page for glue locations between
the lower body tube, fin tubes, and the launch
lug. Attach the first fin tube pair to lower body
tube and launch lug while aligning with the
line around the tube as shown.
