INSTALL ROLL OVER STRIP
You can protect the car and help it keep going when it flips by installing the included Roll Over Strip. Make a test circle from the
Roll Over Strip. Then remove one piece of sticky tape covering to reveal the sticky surface and join the two ends of the Roll Over
Strip to make the circle. Now remove the other piece of stick tape covering from the inside of the circle and secure the it to the base
of the car as shown.
Note: Make sure the Roll Over Strip is positioned so as not interfer with the wheels of the Mini Racer.
Roll Over Strip
Stick Roll Over Strip to
bottom of Mini Racer
Mini Racer with Roll
Over Strip fitted
Position on bottom of
Mini Racer to secure
Roll Over Strip
Secure inside of
Roll Over Strip
to bottom of
Mini Racer
CHARGING BATTERY IN MINI RACER
CHARGING FROM THE TRANSMITTER.
Make sure the transmitter and Mini Racer is turned off. The charge lead
can be found under the cover on the base of the transmitter. Connect the charge lead to the charge port on the left hand side of the
chassis. The charge light will come on, indicating the Mini Racer is being charged. Charging will take about 40mins.
Note: Charging is complete when the charge light on the transmitter goes out.
Charge port is under the body
on the left hand side of chassis
Charge lead is under the
cover on base of transmitter
CHARGING FROM THE USB LEAD.
Make sure your Mini Racer is turned off. Turn on your computer. Insert the
USB lead into a free slot on the computer. A RED light will come on. Insert the other end of the USB lead into the charge port on
the car. The RED light on the USB lead will go out indicating the Mini Racer is being charged. Charging will take about 60mins.
Note: Charging is complete when the RED light on the USB lead is on solid.
OPERATING YOUR MINI RACER
• The transmitter uses advanced 2.4Gz technology allowing precise, stable
control.
• 2.4 GHz technology allows multiple Mini Racers may be operated by
different modellers at the same time without interference.
• Turn on the Mini Racer by moving the switch on the base to ON. The
RED LED will come on. Immediately switch the Power Switch on the
transmitter to ON. The lights on the transmitter will flash then stay on.
• The Mini Racer is now ready for use.
• You can control the Mini Racer left and right using the steering wheel on
the transmitter.
• Speed is controlled by the throttle trigger, pull towards you for forward,
push away from you for backwards.
• In all
ALL SCALE MODE
the car automatically goes from slow to fast to
slow controlled by the throttle.
• In
5 MODE
, you can use the
SHIFT BUTTON
to change gears up and
down to change speeds, with a corresponding LED on the transmitter.
2.4G Antenna
Gear Indicators
Steering wheel
Right & Left
Throttle Trigger
Forward & Backward
Forward & Backwards
Trim Knob
Charge Lead
Charging Light
Mode Change Switch
Power Switch
Power LED
Gear Shift Toggle Shift
Steering Trim
Right & Left
