INSTALLATION STEPS
STEP 1
Do not stand the mirror upright on hard surfaces whilst fitting, as this will damage the corners.
Measure the distances of the four screw fixing slot centers at back of chassis.
ISOLATE THE MAINS POWER SUPPLY TO THE ELECTRICAL FEED THAT WILL
POWER YOUR MIRROR.
STEP 2
STEP 3
STEP 2 STEP 3 STEP 4
Insert the wall plugs and screws on the wall ensuring the screws head is 4-6mm outside.
STEP 4
Decide on position on the wall and mark the four centers
, ensuring your power supply cable will
NOTE
: As the mounting surfaces vary, please ensure adequate fixings are used.
Fixings supplied are not suitable for all mounting surfaces, e.g. plaster board.
reach the connection block
. Drill the four holes into the wall using a suitable drill bit.
