54
55
Settings
Sequencer
•
Metronome:
Enables / disables the metronome click track for sequence recording. Please
note that the sequencer pre-roll (if enabled) will always contain the metronome.
•
Pre-Roll:
Sets the sequence recording pre-roll length to determine how many bars of the
metronome click track you hear before the recording starts.
Note: Metronome and Pre-Roll are only available for realtime sequences
•
Quantise:
Sets the sequencer note recording input quantise value to ensure that played
notes can be kept in time. Please note that this is an input quantise setting and therefore
cannot be used to adjust previously recorded notes.
•
Transport:
Enables / disables the sequencer transport to be controlled by MIDI Clock
Start / Continue / Stop messages from USB-MIDI. You may want to disable this behaviour
if using COBALT8M with an external MIDI sequencer.
Settings
Joystick
•
Mod Wheel Out:
Enables / disables the joystick Y+ axis from transmitting MIDI
Modulation Wheel messages (MIDI CC 1) to MIDI-out. You may want to disable this
behaviour if the COBALT8M is connected to other synthesisers that responds to MIDI
Modulation Wheel messages.
•
Pitch Bend Out:
Enables / disables the joystick X axes from transmitting MIDI Pitch
Bend messages to MIDI-out. You may want to disable this behaviour if the COBALT8M
is connected to other synthesisers that responds to MIDI Pitch Bend messages. Please
note that if this is disabled the joystick X axes will instead transmit CC messages for
MODALapp communication.
•
X+ / X- / Y+ / Y- Calibration:
These are manual calibration settings for adjusting the
usable travel range of each axis of the joystick.
Increase this value if the joystick axis is not reaching the top modulation / MIDI value
(especially in the corner positions), however if too large the usable travel range will be
massively reduced. Decrease this value if the joystick axis has a small usable travel range,
however if too small the joystick may not reach the top modulation / MIDI value.
•
Centre Calibration:
This is a manual calibration setting for adjusting the centring of the
joystick.
Increase this value if the joystick is not properly returning to the ‘centre’ value (it sends
sporadic values when untouched or is too sensitive in its resting position), however if too
large the usable travel range of each axis will be reduced.
Decrease this value if the joystick doesn’t respond to small movements around the centre
position, however if too small the joystick may not centre properly.
Summary of Contents for COBALT8M
Page 13: ...24 25 03 Synthesis engine...
