9
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature (212
F / 100
C), the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
This remote control uses
two AAA batteries (
Not included
).
Instructions for battery installation are on the Remote Control battery compartment.
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
. Dispose of batteries at your local hazardous material processing center.
Care and Maintenance
Cleaning
ALWAYS
turn the heater
OFF
and
unplug the power cord from the outlet
before
cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in
electric shock, fire, or personal injury
.
NEVER immerse in water
or
spray with water.
Doing so could result in
electric shock,
fire, or personal injury.
Metal:
Buff using a soft cloth, slightly dampened with a citrus oil-based product.
DO NOT
use brass polish or household cleaners as these products will damage the metal trim.
Glass:
Use a good quality glass cleaner sprayed onto the cloth or towel. Dry thoroughly with a paper
towel or lint-free cloth.
NEVER
use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
Vents:
Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
Plastic:
Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water.
NEVER
use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
