SECTION 8 – Wire the Output Jack and Footswitch Connections
Please refer to DRAWING 9.
250K Pot lug #3 & Output Jack ground lug
1) Strip and tin a 1" piece of wire and connect:
12
GROUND LUG
TIP LUG
Output Jack
2) Connect the free end of the 0.1
µ
F cap from Terminal #3 to Footswitch lug #3
RING LUG
GROUND LUG
TIP LUG
Input Jack
Input Jack tip lug & Footswitch lug #2
3) Strip and tin a 2 ½” piece of wire and connect:
250K Pot lug #2 & Footswitch lug #6
4) Strip and tin a 4 ½” piece of wire and connect:
Footswitch lug #1 & Footswitch lug #4
5) Strip and tin a 1 ½” piece of wire and connect:
Output Jack tip lug & Footswitch lug #5
6) Strip and tin a 3 ½” piece of wire and connect:
SECTION 9 – Finishing Up
Attach the knobs provided to the two potentiometer shafts. Install 9 volt battery, close cover using
screws provided. Plug guitar into input jack on right. This turns unit on. Plug cable into output jack
and plug into your amplifier. Battery will last only about 1 hour of continuous operation. 9 volt,
center negative power supply is highly recommended for use with this unit.
Unplug from the input jack of the unit to turn it off and save power.
It’s always a good idea to thoroughly double-check your connections before applying power.
Terminals #14 & #15
5) Mount the 0.047
µ
F capacitor to:
Terminal #10 & Tube pin #2
(
Do not solder the connection at pin #2, yet.)
6) Mount the 15K resistor to:
Terminal #11 & Tube pin #2
(
Now solder the connection at pin #2.)
7) Mount the 4.7K resistor to:
Terminal #12 & Tube pin #1
8) Mount the 68K resistor to:
Terminal #16 & Tube pin #6
4) Mount the 33K resistor to:
Footswitch lug numbering convention
input
jack
output
jack
1
3
6
4
2
5