NOTE!
This guide is only valid for
installing and connecting
the 2MP Speed Dome Low Light Camera.
For more information on the camera, please refer to the other documents (see
).
Important Installation Notes
n
This camera must be installed by qualified personnel and the installation should conform to
all local codes.
n
To prevent damage, loosen the mounting screws before moving the camera.
n
To ensure that the unit is not affected by vibration, twisting, etc. after adjusting the camera,
tighten all mounting screws properly.
n
This product must not be used in locations exposed to the dangers of explosion.
n
Install this product in a well-ventilated spot and do not close off any vent openings.
n
Do not use this product in a dusty environment.
n
Protect this product from moisture or water entering the housing.
n
Install this product as outlined in this document. A faulty installation can damage the
product!
n
Do not replace batteries of the camera. Risk of explosion may occur if the battery is replaced
by an incorrect type.
n
This equipment is not suitable for use in locations where children are likely to be present.
n
External power supplies must comply with the LPS requirements and share the same power
specifications with the camera.
n
If using a Class I adapter, the power cord shall be connected to a socket-outlet with proper
ground connection.
n
To comply with the requirements of EN 50130-4 regarding the power supply of alarm systems
for 24/7 operation, it is highly recommended to use an uninterruptible power supply (UPS) for
1 / 9
Quick Installation
MOBOTIX 2MP Speed Dome Low Light Camera
Mx-SD1A-230-LL
© 2022 MOBOTIX AG
