Security-Vision-Systems
EN
MOBOTIX AG • D-67722 Langmeil • Phone: +49 6302 9816-103 • Fax: +49 6302 9816-190 • [email protected]
FlatMount Frame: Quick Install
www
.mobotix.com
MX-OPT
-FlatMount-EXT
32.143_EN_V2_11/2014
FlatMount Frame for all
Door Station Modules
Installing the FlatMount Frame
Installation with In-Wall Housing
1. Lead Cable into the Housing
The housing has several cable inlets. Pierce through the required inlet with,
for example, a screwdriver. Make sure that you pierce through the inlet that is
closest to the required cable connection, i.e., use the upper inlet for a two-wire
cable and the lower for an installation cable.
2. Insert Housing
Prepare the installation opening for the in-wall housing (W x H x D):
112
x x
60 mm
. You can use the reverted housing as a template to mark the opening.
Lead the cable into the housing. Make sure that the cable is long enough (about
40 cm/16 in), so that the wires can be connected easily to the FlatMount Frame.
Excess cable can be stored in the housing by winding it up in a spiral. Insert the
housing. Connect the in-wall housing in such a way with the underground that
the front edge of the housing lines up precisely with the housing surface.
Set the protective cardboard cover (included with the delivered
parts) into the housing before pushing it into the wall cavity. This prevents cement
from entering the interior of the housing. After you have installed the housing into
the wall, you can easily remove the carton by pushing through the pre-cut opening
and pulling it out.
3. Attach FlatMount Frame
The FlatMount Frame has an electromagnetic theft protection,
which prevents extracting the module. When attaching the frame,
make sure that the arrow on the red knob (theft protection) points
at the “open lock” icon and that the frame is positioned in such a
way that the red knob is on the bottom left corner of the frame.
!
Caution:
In situations, in which a theft protection is not necessary, e.g., indoor installations,
do not
activate the theft protection (the red knob remains in the “open lock” position).
If you twist the knob by mistake, you have to be able to attach a battery (9 V DC).
Otherwise, the frame cannot be released!
Position the clamping brackets at the ends of the screws in such a way that the screws are easily led
past the notches of the housing when you attach the FlatMount Frame. After attaching the frame,
tighten the screws and make sure that you do not overtighten them. By tightening the screws, the
clamping brackets automatically engage into the notches of the housing.
Delivered Parts
Item
Number Part Name
1.1
1
FlatMount Frame with short
clamping brackets
1.2
4
Clamping brackets, long
1.3
1
Allen wrench 2.5 mm
1.4
1
FlatMount Frame ruler
1.1
1.4
1.2
1.3
124 mm/4.88 in
124 mm/4.88 in
Important Notes
• The FlatMount Frame is only to be used together
with the MxDisplay, the MOBOTIX door station
modules and the in-wall housings.
• Make sure that you are installing this product on a
solid surface that provides for a sturdy installation
of the fixing elements used.
• Make sure that the power supply is disconnected
before you insert or detach the modules.
• This product must not be used in locations exposed
to the dangers of explosion.
Order No.: MX-OPT-FlatMount-EXT-BL (black)
Order No.: MX-OPT-FlatMount-EXT-PW (white)
• For MxDisplay and all door station modules
• For internal and external installation
• In black or white
• Including module theft protection
• In-wall or cavity wall mounting
