The HiRes Video Company
EN
MOBOTIX AG • D-67722 Langmeil • Tel: +49 6302 9816-0 • Fax: +49 6302 9816-190 • www.mobotix.com
AudioMount: Quick Install
1. Remove and re-attach camera
Remove the Allen screws (item 1.6), turn the camera
around and attach it to the AudioMount. Make
sure that you lead the cables on the left side
around the four black mounting pegs. Screw the
camera with the Allen wrench (item 1.7) to the
mounting pegs using Allen screws (item 1.6) and
metal washers (item 1.3).
Thickness of material:
The AudioMount is constructed
for sheet metals with a 3 mm thickness. If the
material is less than 2,4 mm thick, additional
washers have to be put between the mounting
pegs and the back of the S15, so that the dome
of the camera lens attains its optimal position.
2. Attach cable tie
Remove the protective foil from the cable tie (item
1.8) and stick it to the left side of the camera.
Secure the audio cables with the cable tie.
Finishing the Installation
MxBus
AudioMount with
mounted S15M
Door
Door Opener and
Lock Sensor
DoorMaster
Door Sensor
e.g.,
MX-232-IO-Box
to
connect door bells
MxBus
NPA-PoE-Set
Remote Stations
Patch Cable (RJ45)
Setup of the Camera
You find detailed information to the standard installation in the S15 Camera Manual, Section 3 „Operating
the Camera“.
1. Establish PoE power supply
2. Put camera into operation
3. Optional: Start auto configuration
If you would like to use the FlexMount camera in conjunction with the AudioMount as a door station, you
can run the auto configuration with the aid of the camera buttons now. To do this, reboot the camera by
disconnecting and reconnecting the PoE power supply. After the reboot, press the camera buttons according
to the description in the S15 Camera Manual, ” Setting up an S15 FlexMount as a Door Station“ and configure
the connected door station modules (e.g., bell and DoorMaster).
• When using a solid core wire cable (instead
of a patch cable), lead that cable through
the camera opening for “additional“ cables.
Remove the bayonet catch on the left camera
opening and insert the cable plug that holds
the additional cables (see S15 Camera Manual,
Chapter 2).
• If a USB decive is to be connected, insert the
MiniUSB cable into the MiniUSB plug (see S15
Camera Manual, Chapter 2).
3. Attach housing cover
Attach the black front cover with dome included
in the delivered parts (item 1.2) to the camera and
fasten it in place. The previously removed white
front cover is not needed.
Thickness/Material Washer
1,20 - 1,79 mm
blue
1,80 - 2,39 mm
red
2,40 - 3,00 mm
none
Copyright © MOBOTIX AG 2013 • Made in Ger
many • T
echnical infor
mation subject to change without notice.
Display available in the future
