MOBILUS COSMO | HB Lite, User Manual

Page: 5 / 8

CONTINUED 7. READING OF REMOTE INTO THE MOTOR’S MEMORY
Fig. 7.2
ON OFF ON OFF
2x
a b c
5 s.
WARNING! The first remote control readed into the receiver is a remote control MASTER.
It allows you to operate motor and enter it in the PROGRAM MODE OF OTHER REMOTES.
3. On the remote control simultaneously press the P1-
Fig. 7.3a.
4 LEDs start blinking
- Fig.
7.3b
. Hold the button until the motor driver will perform two micro-movements. The
remote control has been readed into the motor.
Fig. 7.3a
P2 P1
Fig. 7.3b
8. READING IN OTHER REMOTE
1. On the MASTER remote control press the P1
- Fig. 8.1a
. 4 LEDs start blinking
- Fig. 8.1b
.
Hold the button until the motor driver will perform one micro-movement confirming
the input of the motor in the PROGRAM MODE.
Fig. 8.1a
MASTER PILOT 2 MASTER MASTER
P2 P1
Fig. 8.1b
MASTER PILOT 2 MASTER MASTER
2. On the second remote control, you want
to program, press the
and
- Fig. 8.2c
. or for another
COSMO | HB lite - press the programming
button P1 . Hold the button until the motor
driver will perform on micro-movement
-
Fig. 8.2d
. Another remote was loaded into
the motor.
FIg. 8.2c
MASTER PILOT 2 MASTER MASTER
Fig. 8.2d
a b c
4 s.
Within 20 sec. you can proceed to load the next remote. However, if no action of programming at this
time doesn’t happen, motor automatically returns to the OPERATING MODE. You can expedite return
to the OPERATING MODE manually using the remote control MASTER. In this case, press the button
P1 and hold more than 5 seconds. In both cases, return to the OPERATING MODE will be confirmed
by two micro-movements of the driver.