3. REMOVAL OF INDIVIDUAL REMOTES (CHANNELS)
It is possible to delete only one of the programmed remotes (not for MASTER remote). To do
this:
1. On the
MASTER
, press simultaneously and hold the
STOP
and
UP
buttons until the
connected actuator executes one sequence of noticeable and audible micro movements
down / up, confirming the receiver’s entrance into the programming mode
- Fig. 3a
.
2. On the remote control (channel) that you want to delete, press and hold the
STOP
and
UP
buttons simultaneously until the connected actuator performs one sequence of noticeable
and audible micro movements down / up, confirming the removal of the pilot code from the
actuator memory
- Fig. 3b
.
Fig. 3
MASTER
PILOT 2
a
b
WARNING!
Repeat step 2 to proceed to remove the next remote control. However, if within
20 sec. no programming operation is started, the receiver automatically returns to operating
mode. Return to operating mode can also be performed manually using the
MASTER
. In such
a situation, simultaneously press and hold the
STOP
and
MASTER
buttons until the connected
actuator executes one sequence of noticeable and audible micro movements down / up. In
both cases, the return to operating mode will be through one sequence of micro down / top
moves of the connected actuator.
11
