MobilSat
Mounting Instructions
– User Manual
Page 9 of 16
When the system has been connected correctly to a power supply, an auto test will be
performed. If an error message appears on the display, look up the cause specified in the user
manual section
1.5.9
Protection circuit
IMPORTANT
In order to avoid damages by inadvertently driving with the external unit folded-up, connect the
yellow cable to the +15 vehicle line or the D+ line that carries voltage when the engine is on and
no-voltage when the engine is switched off. In this way the external unit will be automatically
retracted when the caravan engine will be switched on.
1.5.10
Cabling between control and command units
Connect the 4,5mt cable between the control and the command unit; take care of inserting the
RJ11 connector in the right direction and push them until you here a click. If the cable is too
long, coil it up near the control unit, fixing it appropriately.
1.5.11
Connection to the satellite receiver
Now it’s possible to connect the antenna system to the satellite receiver, using the F-connector
cable.
