Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
Pedal trainer – item no. 272002
Pedal trainer - item no. 272003
Product description
Foldable pedal trainer with a 2-colored steel frame.
The pedals have safety straps and the pedal
resistance can be adjusted.
Safety requirements
●
Make sure that this user manual is read by
all persons using the device. Manufacturer
don’t take any responsibility for damages
and/or injuries, caused by the fact that the
user manual has not been followed.
●
Only use the product in flawless condition.
●
If defects or errors are detected you must
immediately contact the dealer.
●
Follow the information on the product label.
●
Only use the product for the described
purpose and only on even and flat surfaces.
●
Do not stand on the pedal trainer.
●
Use only sitting in a chair with the pedal
trainer placed safely on the floor or by
training of the arms, only placed safely on a
surface of the right height.
Assembly
●
Remove the device from the box and insert
the adjustment knob.
●
Turn the legs outwards until they both click
in place.
Adjusting the pedalling resistance
The adjustment knob is for adjusting the resistance
in the pedals. Turn the knob clockwise. Tighten
or loosen as desired.
WARNING!
Device may get hot by extended use!
Cleaning & Maintenance
Normal dirt on metal and plastic parts can be
removed with standard cleaning agents. Check the
specific product information and use only
commercial cleaning products which are suitable for
cleaning and disinfection (no solvents or abrasives).
Recommended service life:
Normally 10 years
depending on use.
Reuse
The product is suitable for recycling.
Disposal of the product
The product may not be disposed of with household
waste but must be brought to the local recycling
site.
Model with LCD Display
The 272003 model differs from the 272002 model on
the additional multifunctional LCD display.
The display provides the following functions:
1. Mode
(red button). This control allows you to
select a particular function. To start, press and hold
the Red Button for 4 seconds. The LCD will display
the different functions (after a few
minutes without movement, the
unit will automatically shut off).
2.
To select a function, wait until
the 4 second setup is complete.
Push the red button and the arrow
will move through the functions.
When the desired function is
selected, simply use the pedal
trainer and the unit will calculate
the exercise.
3. Time
: Determines the amount of the time the
pedal trainer has been operating.
4. Counter (CNT)
: Determines the amount of steps
while operating the pedal trainer.
5. Calorie (CAL)
: Determines the amount of
calories burned while using the pedal trainer.
6. Reps per minute (RPM)
: Automatically
calculates the repetitions per minute.
7. Scan
: Will automatically show the results of all
functions.
Battery replacement
If the display does not turn on or reads incorrectly,
the battery requires replacement.
To replace the battery, use a small screw driver and
remove the display panel. Turn the display panel
over and remove the watch-style battery. Insert a
new battery and insert the display panel again.
Rev. 10/05/21
page 2 of 8
UM-272002-03-Multi_26042021
a better life in motion
GB
GB