2
MobileView 9000 Series Exterior Analog/IP Camera Quick Guide
Figure 1 lists the requirements for the cables that
connect to the camera. Note that the camera has two
options to receive power; only one should be used at a
time.
Table 1: Recommended power cable requirements
PoE(802.3af):
12VDC:
Cat5, or better
18 AWG, or larger
Camera Description
Figure 1: MVC-9000 Exterior Camera
5
4
1
3
2
7
6
8
9
1. Cover
2. Bubble
3. IR
4. Base
5. Lens
6. BNC Cable
7. 12VDC Molex connector
8. Ethernet RJ45 cable
9. Reset Button
Setting up the Camera
To quickly put the camera into operation:
1. Prepare the mounting surface.
2 Mount the camera using the appropriate fasteners.
See the following “Mounting the Camera” section.
3. Set up the camera’s network and streaming
parameters so that the camera can be controlled
over the network. See section “Accessing the
Camera over the Internet.” For further information,
please refer to the “MobileView 9000 & 9100 Series
Analog/IP Camera User Manual”.
4. Program the camera to suit its location. For further
information, please refer to the “MobileView 9000 &
9100 Series Analog/IP Camera User Manual”.
Mounting the Camera
To Mount the Exterior Camera:
1. Use the supplied template to mark out the mounting
area. Drill the screw holes on the surface. Rivnuts
with #8-32 machine screws (or larger) are
recommended.
2. Loosen the cover screws, so cover can be removed.
Secure the mounting base to the surface with
appropriate screws.
3. Loosen the adjusting screw to adjust the pan, tilt and
rotation angle, then re-tighten the adjusting screw
.
4. Reinstall the cover screws.
Accessing the Camera over
the Internet
Use the camera web browser to access and configure
the camera over the internet (Microsoft Internet
Explorer). Only one camera is accessible from a single
web browser window.
