Sheet 5 of 8
LED AREA LIGHT
The Spotlight is equipped with bright LED lights embedded in
the rim. These will provide an area light for working and general
illumination. To operate,
Press the switch on handle of the spotlight to “LED” position.
Area light will operate continuously for many hours on a full charge.
Press the switch to “O” to turn off the LED lights.
VEHICLE JUMP START INSTRUCTIONS:
WARNINGS:
Vehicles equipped with on-board computers may be
damaged if the vehicle is jump started. Review and understand
your vehicle owner’s manual instructions before attempting to
jumpstart your vehicle. Failure to follow these advisory instructions
may result in personal injury and property damage. Use Safety
Glasses to protect your eyes while working near battery during
jump-staring a vehicle. Jump start a vehicle in an open area without
any type of obstructions.
1. Turn off the vehicle ignition and all the accessories (Such as
radios, lights, and air conditioners, etc).
2. Apply the emergency brake and put those vehicles with automatic
transmission in park position.
3. Determine the polarity of the vehicle battery terminals. The
positive (+) battery terminal normally is larger in diameter than the
negative (-) terminal. If you are unsure, you must refer to the
vehicle owner’s manual.
4. Determine whether your vehicle designed with a negative or
positive grounded system: In the Negative Ground System, the
negative battery terminal is grounded to chassis of the vehicle.
Most vehicles use this type of system. Positive Grounded battery
terminal is grounded to chassis or any other part of the vehicle. If
you are not certain of this important information,
YOU MUST
REFER TO YOUR VEHICLE OWNER’S MANUAL.
5. Remove clamps from the holders. Never allow clamps (positive &
negative terminals) to touch together or contact the same piece
of metal to prevent short-circuits.
6. Follow the instructions for a Negative Grounded System or
Positive Grounded System as indicated below:
