MDVR User Guide
- -
12
Vibration:
If necessary, provide additional shock mounting to prevent damage and wear
by excessive vibration.
Clearance:
Front clearance of 8 inch is required to slide the recording module from the
mounting assembly.
Wiring:
Install where mounting assembly wires have sufficient clearance and will not
be crimped or subject to wire insulation damages due to vibration.
Access:
Secure the MDVR so that passengers or drivers cannot tamper or damage
the unit, cameras, wires or other accessories. Do not mount where access to
any other vehicle component will be restricted.
Injury:
Install the unit, cameras, accessories and wires so that no injuries can be
caused through impact with equipment during vehicle operation. Ensure that
all transportation regulations are followed to avoid passenger injury should
they come in contact with the installed
Installation Instructions
Follow these guidelines when installing the MDVR:
Remove all components provided in the package.
Disconnect any power supply or device.
Locate a proper spot to install the mounting assembly and provide any additional shock
absorption if necessary. Locate a reliable electrical ground point in the vehicle.
Make all connections to the rear of the mounting assembly.
Connect power source and turn the vehicle ignition (make sure this connects with “Signal”)
to test the unit.
Observe completion of the unit power-up procedures as described in section labeled
“System Startup and Shutdown”.
Maintain any labeling information required by local or state statutes for video surveillance.
