Equipment Checklist
Carefully unpack your Card Presenter, and keep the packing materials for future reference. Check to
make sure that the following items are included:
•
Mobile Edge Wireless Remote Presenter (with USB receiver)
1
•
CR2032 lithium cell battery
1
•
User’s Manual
1
System Requirements
It is recommended to install this wireless presenter under one of the following Operating Systems
•
Windows¨ 98 SE, ME, 2000, XP
•
Mac¨ OS9.1 or later, Mac¨ OS X (10.1) or later
Product Features
Parts Description
Figure 1
Removing and Storing the Receiver
Note:
Improper removal and insertion may damage the receiver, please follow the diagram below.
Figure 2
Getting Started
Initial setup for the Wireless Remote
Step 1:
Battery Storage - Open the battery cover and insert the battery. (Refer to Figure 1)
Notes on battery
• Do not insert battery into the presenter in the wrong direction.
• Do not charge, heat, open, or short-circuit the battery.
• Do not leave dead or exhausted battery in the presenter.
• If the presenter will not be used for a long period of time, removing the battery will reduce the risk
of damage due to battery corrosion.
• If the presenter does not function correctly or if the operating range is reduced replace the battery.
Step 2: Linking the Receiver -
Remove the receiver and plug it into an available USB port on your
computer. (Refer to Figure 2) You may encounter the following conditions with different Operating
Systems:
• Windows¨ 98 SE/ME - The system may prompt you to insert the operating system CD-ROM and
the follow the instruction to install the software required.
• Window¨ 2000/XP - The system identifies the receiver, prompts ”USB Human Interface Device”
and begins installation automatically. Please follow the instructions on the screen to complete
the installation.
Note:
It is recommended that you use the link option to make sure no other wireless products are
working at your same frequency, which may cause interference. Please follow these simple procedures.
Using the Link Option
a. Press the link key on the receiver (connected to your computer now), and the LED light on the
receiver will come on. (Refer to Figure 1)
b. Press Fn button and the Link button on the Wireless Remote simultaneously for more than three
seconds. The LED on the receiver will start flashing to confirm the link is complete. The Wireless
Remote is now ready for use.
Note:
Whenever you change new battery, it is recommended that you repeat the Link process again.
Using the Card Presenter
There are six buttons on the Card Presenter. The Fn button does not function except when used simul-
taneously with another key. The function of each button is described below.
Normal mode:
Function of each button when not used with the Fn button.
Function mode:
Function of each button when used with the Fn button.
Note:
The Fn button should always be pressed before depressing the other button.
Note:
The laser button will automatically deactivate if it is idle for more than 30 minutes.
Red Buttons
Function
Laser
Activate the laser point first by pressing and holding the Fn & Laser buttons simultaneously
over 3 seconds. (Warning: Never point the laser beam into human or pets eyes)
Next
Advance to the next page
Prev.
Return to the previous page
Right Arrow
In some modes - advance to next slide
Left Arrow
In some modes – return to previous slide
ESC
To exit slide show mode
Black Buttons
Function
Fn + On/Off
Switch the laser beam on or off
Fn + Black (dark circle)
Turn the projector beam to black screen
Fn + White (open circle)
Turn the projector beam to white screen
Fn + Link
Link the ID with the receiver