23
7.2
HOW TO ACTIVATE THE WATERGUARD
After the previous steps the Mobeye WaterGuard is ready for use. It is armed
automatically.
In order to switch off (disarm) the WaterGuard:
- Press the button at the backside for 1 second. The
green LED switches off to indicate the disarmed
status.
In the disarmed status the Mobeye WaterGuard
will not send alarm notifications. The unit remains
active and is able to switch on time-controlled and
to send 'low battery voltage' messages.
In order to switch on (arm) the Mobeye WaterGuard:
- Press the button at the backside for 1 second. The green LED blinks once
every 3 seconds (battery-powered) or stays on continuously (in case of an
external power supply).
If powered externally (with network connection), switching can be done via
SMS commands:
SMS command to switch on:
CODE ARM
(e.g. 1111 ARM)
SMS command to switch off:
CODE DISARM
(e.g. 1111 DISARM)
7.3
SYSTEM RESET
To reset the Mobeye WaterGuard to its factory settings:
1.
Remove the batteries (and external power supply).
2.
Press the outside button while reinserting the batteries. Keep it pressed
for (about) another 5 seconds.
3.
Release the button immediately after the LED starts to flash.
4.
If relevant, connect the external power supply.
After a successful reset, the status LED will blink green to indicate that the
module is not configured. The security code is back to factory settings as
well.
