Mobatime 121059, Mounting And Instruction Manual

Page: 106 / 124

© MOBATIME 106 / 124 801203.10
C Alarm list
Nr. Error message Description Action Chap.
0 Reboot DTS DTS 4210 restarted

no intervention required
1 System Warning
Internal system Warning
(Baseboard, board 1) Check dts.log for detail Warning
information
2 Supply voltage too low
Power failure (internally
measured)

support
3 Failure red. supply
Power failure redundant supply
(only if redundant supply is on)

Check in the menu which
power supply fails
4 Internal voltage to low
Power failure (internally
measured)

support
5 To high offset to GNSS To high offset to GNSS

check GNSS time source
6 To high offset to PTP To high offset to PTP

check PTP time source
7 To high offset to DCF To high offset to DCF

check DCF time source
8 Too high offset to FREQ To high offset to Frequency-In

check FREQ time source
9 Too high offset to E1 To high offset to E1

check E1 time source
10 PTP synch lost

check PTP time source
11 DCF synch lost

check DCF time source
12 FREQ synch lost

check FREQ time source
13 E1 synch lost

check E1 time source
14 Lost GNSS time source Bad GNSS reception quality

check GNSS Antenna
installation

check GNSS Configuration
A.3
6.5.15
15 Time source big offset Big offset to timesource detected

check time source
16 Time source lost Stratum too high

check time source
17 Failure time source TO
No time information from the
selected time source within the
configured timeout

check time source

In slave mode: check link
6.5.9, 6.5.10
18 No valid time 20 min after starting no valid time

Check time source 6.5.9
19 NTP synch lost

Check NTP configuration
20 Too high offset to NTP

Check NTP time source
21 NTP Error NTP not running

Check NTP configuration
22 Error bit 22 Not used
23 No valid time source

Check synchronization and
source settings
6.5.10
24 No mail server
No connection to configured mail
server

Check e-mail configuration,
check connection
6.5.21
25 SNMP Error SNMP not running

Check SNMP and trap
configuration
6.5.22
26 Error bit26 Not used
27 Error bit27 Not used
28 Error bit28 Not used
29 NTP Configuration Error
Configured NTP Authentication
Key is not correct

Check the configured NTP
trusted keys against imported
key file.

Check the configured keys
for multicast against configured
trusted keys

see dts.log file for details
6.5.12
30 Error bit 30 Not used
31 No DTS link (optical)
No connection via optical link in
redundant operation.

Check redundant link
connection.
32
Change
Slave->Master Switch over slave -> master has
occurred.

Optionally, check the time
source of current slave.