© MOBATIME
103 / 124
801203.10
Requirements for general active antennas
Frequencies
GPS L1, GLONASS L1
Impedance
50 Ohms
Amplifier gain
The active antenna must amplify the signal to
compensate the signal loss in RF cable and lightning
protection.
E.g. Antenna is connected with two cables and the
lightning protection.
Cable A
10 m RG 58 C/U
Cable B
10 m RG 58 C/U
Total attenuation
19.2 dB
(referring to the table
on page A.3.3Distance between antenna and DTS 4210)
Minimal amplifier gain
19.2 dB
Maximum noise figure
1.5 dB
Polarization
Right hand circular
Operating DC voltage
5V
Max. current
100mA (with inserted inline amplifier 85mA)
A.4
Plug-in spring terminals
M
ultiple contact strip 100% protected against wrong plug;
WAGO CAGE CLAMP®-connection
Cross section of 0,08 mm² to 1,5 mm² (from AWG 28 to AWG 14)
Voltage CSA 300 V / current CSA 10 A
Rated voltage: EN 250 V
Rated surge voltage: 2,5 kV
Nominal current: 10 A
Strip length: 7 mm (0,28 in)
Pulled off spring terminal with operation tool:
2 operation tools are delivered with the accessory bag.
