Panel Heater
- English manual
5
EN
Installation for the wall mounting mode
The appliance must be installed at least 100cm above the fl oor. The
appliance must be installed at least 50cm below the ceiling and next
to the fl ank wall. Drill two holes in the wall and have a distance of
1.8m from the fl oor. The diameter of the hole just contained the infl ated
plastic pipe. The distance between two holes just with the distance
between two hang-holes in the appliance. After tucking the infl ated
plastic pipe, fi x screw, do not screw the entire length into the wall,
leave at least 3-5mm out of the wall. Make sure the screw is fi xed fi rmly
and hangs the appliance. The screw should be inserted rabbet of the
appliance bottom.
Operation
1. After unpacking:
a) Inspect the device for visible damage. Do not forget to unpack the
two feet. Mount the two feet at the bottom of the unit.
b) Connect the power cord directly into a grounded outlet.
c) Connect the unit to a properly installed power outlet (at least 15A /
220V).
d) After use, remove the plug from the socket.
Heating
a) Turn the temperature knob to the right, the heater is turned on. Set
the thermostat to the highest temperature MAX.
b) Once reached the desired temperature, turn the thermostat
counterclockwise along until it reaches the thermostat the unit turns off
by an audible “click”.
c) The set room temperature is thus maintained by the convector almost.
The position of the knob
a) Turn the knob to the desired heating level is selected.
Position 1 = 1250W
Position 2 = 2000W
b) The thermostat switches the convector on automatically and off. If
the set temperature falls below the convector begins to heat up until the
temperature is reached again.
c) The thermostat turns off the heater when the activated room
temperature is reached. The indicator does not light.
