MO-EL LUCCIOLA, Use And Maintenance

Page: 11 / 60

11
earthed.
The appliance must be connected to energy supply line by
means of the provided H05SS-F silicone cable.
An overvoltage category III Combined Circuit breaker and
Residual Current Device (RCD) with rated earth leakage ope-
ration not exceeding 30mA must be fitted upstream on the
supply line. The circuit breaker must have a contact opening
distance of at least 3 mm.
If the supply line where the heater is connected is protected
by fuses, be careful they are 16 A not quick-acting type.
• The heaters should always be installed only using the mounting
brackets provided or supplied as fittings.
• A minimum air gap of 40 cm should always be allowed between
the top of the heater and a ceiling or roof. The appliance should be
60 cm far from the walls (fig. 1).
• A safety distance of not less than 100 cm should always be left in
front of the Lucciola heaters or too near.
• This unit should be mounted at a minimum of 180 cm above ground
level (fig. 1). If installed in a toilet, the height should be 225 cm in
zone 1 and zone 2; in zone 3 the minimum above ground level is
180 cm, according with the rules of each Country.
• The appliance must not be located neither directly below, nor in
front of a socket-outlet.
• The heater must be installed so as to prevent that the switches can
be touched from those who are in the shower.
• Ensure that there is no possibility of inflammable material, com -
bustible material or curtains coming into contact with the heater,
or lie near the heater.
• If the heater is fastened to a patio umbrella or similar, be sure that
neither the sheet nor other floating parts can inadvertently enter
into the range of the emitters.
• If the heater is fastened to a patio umbrella, let it touch the sheet
only after 5 minutes after its switching off.
• The heaters are fitted with safety guards. These are intended only
to stop large objects from hitting the emitters. On no account
should the heater be operated with the guard removed.