S
UGGESTED
H
OOKUP
D600.2
SPEAKER
OUTPUTS
+ - + -
+ -
+ -
4 OHM
4 OHM
HOOKUP INTO TWO 4 OHM WOOFERS
D600.2
SPEAKER
OUTPUTS
+ - + -
-
+
4 OHM 4 OHM
+
-
HOOKUP INTO ONE DUAL VOICE COIL
(4 OHMS PER COIL) WOOFER
F
EATURES
Ultra- Efficient Class D Audio Output Stage
Regulated Pulse-Width-Modulated Power Supply
High Capacity Heat Sink
Adjustable 12db Low Pass Filter
Adjustable 45Hz Bass Boost
Low Level and Speaker Level Inputs
1% Surface Mount Components
Computer Optimized Transformer
Large Geometry Power MOSFETs
Overload and Thermal Protection
C
ONTROLS AND
C
ONNECTORS
1.
Positive Power Terminal
- This is the power feed from the
positive (+) terminal of the car’s battery. Use 8 gauge cable
and good quality terminals when routing this connection.
Tighten the connections well to prevent power loss due bad
contact. Route the power cable away from the RCA and
speaker cables
2.
Fuses
- Replace these fuses with only with the same type
and value.
These fuses only protect the amplifier. An
additional inline fuse should be added at the battery to
protect against a short in the main power cable to the
amplifier.
3.
Ground Terminal
- For optimum performance, an 8 gauge
cable and good quality connectors should attach the this
terminal to the battery’s negative (-) terminal.
4.
Remote Terminal
- The amplifier will turn on when 12 volts
is applied to this terminal. This 12 volt signal is usually taken
from the Power Antenna or Remote wire coming from the
source unit.
