Basic Assembly Instructions:
1. Install your router onto the Router Plate (#2). Remove your sub-base that is
currently installed on the bottom of your router. Using the appropriate
mounting holes and screws (#11,12,13,14) or the screws from your current
router base, securely install your router to the Router Plate (#2).
2. Install the straight or spiral router bit with which you plan to cut your circle or
ellipse into your router. It is important to do so at this time as the bit diameter
will affect the set up when you adjust for the size of the circle/ellipse being
cut.
3.
Slide the two (2) 1” Flat Washers (#6) on the end of the Steel Rod (#4) that
has flattened shoulders on two sides of one end. Then insert the Steel Rod (#4)
through the mounting Bracket on the Router Plate (#2). The two flattened
shoulders should align with the slot in the mounting bracket on the Router
Plate (#2). Next slide the 3/4” Flat Was
her (#7) over the exposed thread and
secure the Steel Rod (#4) to the mount on the Router Plate (#2) using the
Female Locking Knob (#8). If you are making a circle or an ellipse, add the
#5 Extension Steel Rod by screwing the male threads into the female threads
in the end of the steel rod (#4).
Making A Circle:
Copyright 2007 MLCS ltd. Page 3
