INSTRUCTIONS CFR5xx
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
CFR5WW / CFR5CW
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire
is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
•
This product is Class II double insulated
•
This product is IP65 rated
INSTALLATION
Note -
If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas/water pipes or electrical cables
Fig. 1
•
Connect the luminaire to the mains supply ensuring that correct polarity is observed (see Fig. 2): L -
Live (brown), E - Earth (green/yellow), N - Neutral (blue). The earth terminal is non-functional and only
provided for convenience. Two cables can be inserted into the push-fit terminal block in order to
achieve loop in / loop-out wiring
Fig. 2
Fig. 1
• Connect the luminaire to the mains supply ensuring that correct polarity is observed (see Fig. 2): L - Live
(brown), E - Earth (green/yellow), N - Neutral (blue). The earth terminal is non-functional and only provided
for convenience. Two cables can be inserted into the push-fit terminal block in order to achieve loop-in /
loop-out wiring
INSTRUCTIONS CFR5xx
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
CFR5WW / CFR5CW
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire
is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
•
This product is Class II double insulated
•
This product is IP65 rated
INSTALLATION
Note -
If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas/water pipes or electrical cables
Fig. 1
•
Connect the luminaire to the mains supply ensuring that correct polarity is observed (see Fig. 2): L -
Live (brown), E - Earth (green/yellow), N - Neutral (blue). The earth terminal is non-functional and only
provided for convenience. Two cables can be inserted into the push-fit terminal block in order to
achieve loop in / loop-out wiring
Fig. 2
Fig. 2
• Secure the mains cable under the cable clamp and refit the terminal cover
• Lift both spring clips on the sides of the fitting and push into the ceiling
• Switch on and check for correct operation