INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
RWL2A / RWL2W / RWL5A / RWL5W
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
This product is Class II double insulated
•
This product is IP54 rated
INSTALLATION
Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required
•
Remove the two screws at either end of the fitting which secure the baseplate to the luminaire (see
Fig. 1)
Fig. 1
•
Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to
infringe with any gas/water pipes or electrical cables
•
Secure the baseplate to the surface
•
Remove the screws securing the terminal housing (see Fig. 2)
Fig. 2
•
Feed the mains cable through the rubber grommet to retain IP rating
Fig. 1
• Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to infringe
with any gas/water pipes or electrical cables
• Secure the baseplate to the surface
• Remove the screws securing the terminal housing (see Fig. 2)
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
RWL2A / RWL2W / RWL5A / RWL5W
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
This product is Class II double insulated
•
This product is IP54 rated
INSTALLATION
Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required
•
Remove the two screws at either end of the fitting which secure the baseplate to the luminaire (see
Fig. 1)
Fig. 1
•
Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to
infringe with any gas/water pipes or electrical cables
•
Secure the baseplate to the surface
•
Remove the screws securing the terminal housing (see Fig. 2)
Fig. 2
•
Feed the mains cable through the rubber grommet to retain IP rating
Fig. 2
• Feed the mains cable through the rubber grommet to retain IP rating
• Connect the luminaire to the mains supply ensuring the correct polarity is observed (see Fig. 3): L - Live
(brown), N - Neutral (blue)
