background image

WARRANTY

This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with 
the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will 
invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place 
of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation 
costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve 
the right to alter product specification without prior notice.

GENERAL

The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole 
luminaire should be replaced. 
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not 
use aggressive cleaning products or solvents which may damage the product.  
Do not use any source of high-pressure washers to maintain or clean this luminaire.
This product is non-dimmable.
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities 
for where facilities exist. 

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance 
testing. Irreparable damage will occur if this instruction is not followed.
This product is not suitable for installation in or near a coastal or marine environment

Summary of Contents for FL8ABK









Reviews: