INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following product:
EMTWIN
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
This product is for indoor use only
•
This product is Class I and must be earthed
•
This product is IP20
INSTALLATION
•
Provide power to the required point of installation
•
Open the front cover by unfastening the two screws (see Fig. 1)
Fig. 1
•
Mark the location for, and drill the fixing holes ensuring not to infringe with any gas/water pipes or
electrical cables
•
Carefully remove one of the 20mm knockouts on either side of the fitting, and fit a suitable grommet or
gland (not included)
•
Feed the mains cable into the luminaire and fix to the surface using appropriate fixings (not included)
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown), E
- Earth (green/yellow), N - Neutral (blue)
•
Connect the battery to the battery connector on the PCB
•
Replace the front cover
•
Switch on and check for correct operation, ensuring the CHARGE and LAMPS HEALTHY indicator
LEDs are illuminated
•
We recommend, on commissioning the installation, a minimum charge period of 24 hours before
carrying out an emergency duration test
•
If the batteries have been left in a discharged state for an extended period, we recommend that one or
more charge and discharge cycles are completed which should help to restore the battery capacity
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
GENERAL
Fig. 1
• Mark the location for, and drill the fixing holes ensuring not to infringe with any gas/water pipes or electrical
cables
• Carefully remove one of the 20mm knockouts on either side of the fitting, and fit a suitable grommet or gland
(not included)
• Feed the mains cable into the luminaire and fix to the surface using appropriate fixings (not included)
• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),
E - Earth (green/yellow), N - Neutral (blue)
• Connect the battery to the battery connector on the PCB
• Replace the front cover
• Switch on and check for correct operation, ensuring the CHARGE and LAMPS HEALTHY indicator LEDs are
illuminated
• We recommend, on commissioning the installation, a minimum charge period of 24 hours before carrying
out an emergency duration test
• If the batteries have been left in a discharged state for an extended period, we recommend that one or more
charge and discharge cycles are completed which should help to restore the battery capacity
