INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following product:
EMPDL
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
•
This product is for indoor use only
•
This product is Class II double insulated
•
This product is IP20 rated
INSTALLATION
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas / water pipes or electrical cables
Fig. 1
•
This fitting will suit 70mm – 130mm cut-outs when using the adaptor ring (see Fig. 2)
Fig. 2
Fig. 1
• This fitting will suit 70mm – 130mm cut-outs when using the adaptor ring (see Fig. 2)
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following product:
EMPDL
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
•
This product is for indoor use only
•
This product is Class II double insulated
•
This product is IP20 rated
INSTALLATION
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas / water pipes or electrical cables
Fig. 1
•
This fitting will suit 70mm – 130mm cut-outs when using the adaptor ring (see Fig. 2)
Fig. 2
Fig. 2
• Connect the luminaire to the mains supply via a suitable junction box (not supplied) ensuring the correct
polarity is observed: L - Live (brown), N - Neutral (blue) (see Fig. 3)
