background image

These instructions should be read carefully and retained after installation by the end user for 
future reference and maintenance.
These instructions should be used to aid installation of the following product(s):
AMLEDB / AMLEDR / AMLEDW

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) 

and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the 

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
• This product is Class II double insulated 
• This product is IP54 rated

SAFETY

Note - If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the 
manufacturer of the sensors that they are compatible with LED lamps/luminaires.

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable IP 

rated junction boxes should be used where required

• Remove the diffuser and gear tray from the body
• Drill the fixing holes in the rear of the fitting. Mark the location of the fixing holes and drill ensuring not to 

infringe with any gas/water pipes or electrical cables 

• Drill out one of the 20mm drilling guides on the fitting, and fit a suitable external grommet or compression 

gland (not included)

INSTALLATION

Reviews: