Mkove MK75 Battery Monitor – Instruction Manual
The steps for performing an Over The Air update are as follows..
•
Go to Settings and choose Network, which is on page 2 of the three Settings pages.
•
In Network press either the left or right arrow keys to turn the network on. It will indicate which
mode it is in, normally Access Point mode if the network settings have not already been set. In
Access Point mode it will display the SSID and password required to connect to the battery
monitor. It will also display it’s network address.
•
On a device, such as a computer, tablet or phone, go the the wifi settings and connect to the
battery monitor via wifi.
•
On the same device open a web browser and go to the address shown on the battery monitors
screen, usually 192.168.4.1. This will show the web site from the battery monitor.
•
On the web site there is a button called Wifi Settings, select this and enter the network address
(SSID) and password for a nearby wifi network with internet acesss.
•
The battery monitor will restart and connect to the wifi network.
•
If the battery monitor was able to connect to the wifi network, go to Settings and choose Ota
Update. The battery monitor will look for the update server and will either say “Unable to
connect to update server” if the server could not be found, “There is no newer version of the
firmware” if the version of the firmware that you have is already the latest version or “A newer
version is available” if there is a newer version. If there is a newer version available press the
OK/Menu button to upgrade to it. Note that it can take some time for the new firmware to
download. Once installed the battery monitor will restart.
•
Note that you can always check the version of the firmware that you have installed by going to
the menu and choosing About. We will also publish the current version of the firmware on our
web site at www.mkove.com
Mkove Electronics
Page 9
